Fixed an issue in which the toolpath calculation could fail in certain cases of 2D Contour clearing.Fixed an issue where arc input to 2D Contour could cause the toolpath calculation to fail.Fixed a crash that could occur in some cases in 2D Contour and 2D Pocket when the input paths contained arcs.Fixed an issue that could generate incorrect ordering in a 2D Pocket.Updated error messages to be clearer and more informative.Fixed a case in contour clearing in which rapid moves could cause the tool to collide with the stock. Fixed an issue in which lead-in moves were removed incorrectly in certain cases when using the "Trim" option for holder.Fixed possible holder gouges or incorrect trimming in 3D Contour when using the "Trim" option for holder and the "Axial stock to leave" option.Fixed a case where a toolpath wasn't calculated for contour strategies when using a tool with a shaft that was wider than the tool body.Fixed an issue with missing offset paths for 2D Contour and 2D Pocket.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |